All

All
Product Management
News

News

Home page

2017-05

Thick sheet blister machine operation process of the five steps

thick sheet blister machineFive steps of the operation process:

1. cleaning (bench cleaning, mold cleaning, etc.);

2. open blister preheating machine

1. Turn on the power switch of the equipment;

2. Open the air compressor and vacuum pump for use;

3. After the air pressure of the air compressor is sufficient, open the floating plate to the end point;

4. Lowering the pressure plate to the lowest position;

5. Check whether the mold table is in the lowest position, press the forward button of the heating box after confirming that it is in the lowest position, so that the heating box can move forward until it falls and the pressure plate is sealed;

6. Start the heating button and set the temperature control table, temperature and time (according to different plates and thickness adjustment settings).

Heating stage of 3. plate

1. When the preheating effect is achieved, exit the heating box;

2. Rise the pressure plate to the highest point;

3. Place the plate, put the plate in the best position, and lower the pressure plate until it coincides with the plate and is pressed tightly;

4. Return the heating box to its position, open the heating button, and continue heating;

5. When the above procedure is over, observe the thermometer, such as the temperature buffer drops to the lowest point, or the temperature rise speed, adjust the voltage, temperature, and time according to the actual situation;

6. During the heating process of the plate, attention should be paid to changes, such as blowing frequency, vibration waves on the surface of the plate, and adjust the temperature at any time to prevent the plate from generating bubbles and fission if the temperature is too high;

4. blister stage

1. Exit the heating box after heating the plate;

2. Raises the mold table to the top and lowers the floating plate to the lowest point;

3. Start the vacuum blister button;

4. After the end of the blister, open the cooling fan, so that the product cooling stereotypes.

5. demoulding

1. The mold is lowered, the floating plate is raised, and the pressure plate is raised;

2. Take out the product and place it in the finished product area.

The above content isEternal Blister MachineThe net editor collects and organizes the introduction for you 《Thick sheet blister machine operation process of the five steps"Related content, I hope to help you!! Shenzhen Eternal Sheng Machinery Manufacturing Co., Ltd. has been committed to research and development for 16 years to provide Shenzhen blister machine, Shenzhen bubble shell machine, Shenzhen vacuum blister machine, Shenzhen thick piece blister machine, Shenzhen blister forming machine, Shenzhen thermoplastic forming machine, blister machine hotline: 0755-84817776

Website Keywords：Blister machine, Vacuum blister machine, thick sheet blister machine, blister forming machine, bubble shell machine, thermoplastic forming machine, Shenzhen vacuum blister machine manufacturer,Shenzhen blister machine manufacturer

Shenzhen City Eternal Sheng Machinery Manufacturing Co., Ltd.

Business License

Phone：

Tel：

E-mail：

yongheng@szyongheng.cn