Today, I will tell you about it.Speak.What are the structural components of the blister machineWhat? It doesn't matter if you don't know anything about it, then follow Shenzhen now.YonghengshengBlister machineI'll take a look at the small series.

1. clamping equipment

Plastic sheet molding, sheet fixing in clamping device. Thermoforming machines, in general thermoforming compounds in fixed clamping equipment for plates of various sizes. There is a whole molding machine with a clamping frame.

The clamping equipment is optimally controlled automatically, with agile moves that contribute to the progress of quality and power.

2. heater

Two, heating equipment vacuum thermoplastic sheet and film composition process, a primary process is sheet heating. The time and quality depend on the heater's electric heating structure, the thermal inertia of the radiant surface temperature of the heat transfer, and the distance between the sheet heater, the radiation absorption coefficient, the appearance properties of the heater and the thermophysical functions of the material, commonly used heaters, electric heaters, radiators and infrared crystals.

Third, vacuum equipment

The vacuum system is composed of vacuum pump, air storage tank, pipeline, valve and vacuum gauge. It is generally used for separation vacuum pump in vacuum forming. The vacuum pump should reach0.07~0.09 MPa (520mmhg) above. The gas tank is generally welded with thin steel plate cylinder, the bottom is oval. The capacity of the gas tank should be at least more than half of the maximum space capacity. Vacuum line, must have the appropriate valve, in order to control the vacuum narrow ability.

The rolling power vacuum pump is determined by the size and speed of the forming equipment, and the larger or forming speed equipment is more common.2-4kw. The vacuum system is produced and carried out according to the requirements of the factory planning.

Four, tight air equipment

After its own compression molding machine pneumatic system, gas tank, workshop director land machine, valves and so on. The pressure requirement of the compact air of the molding machine0.4, vacuum plastic molding machine is widely used in piston air compressor. It is also possible to use large integers supplied by the screw air compressor plant.

In addition to air compression molding, when a somewhat dynamic release, the earlyProductsExternal cooling and mold construction and operation of the action piece parts.

Five, cooling equipment

In order to improve the production power, vacuum formingProductsThe release usually requires cooling. The ambition is that the inside and outside of the mold cooling workpiece contact the outside, the best use of the mold cooling coil. Non-metallic molds, such as wood, plaster, glass fiber reinforced plastic, epoxy mold, can not use water, can use air cooling, and other water mist exterior cooling, vacuum formingProducts. If the production of natural cooling can be obtained through annealing, it is helpful to improve the impact resistance function of the parts. Water cooling power is high, but some internal stress.

            SHENZHEN YONGHENGSHENG MACHINERY MANUFACTURING CO., LTD19 years has been committed to research and development to provide ShenzhenBlister machineShenzhen bubble shell machine, Shenzhen vacuumBlister machine, Shenzhen thick filmBlister machine, ShenzhenBlister forming machineMachine, Shenzhen ThermoplasticMoldingMachine,Blister machineHotline:0755-84817776If you want to know more knowledge, you can also go to the official website to have a look.www.szyongheng.cn/