Today I will tell you about the installation process and troubleshooting of the high-speed blister machine. It doesn’t matter if you don’t understand it like this, so let me follow the editor of Shenzhen Yonghengsheng Blister Machine.

 

         What is the process of a high-speed blister machine? It is necessary to be able to correctly align the two workbenches, and then connect the gas pipeline and related lines, but here you need to pay attention to it, be sure to connect the ground wire. It is recommended to use a leakage protector to effectively ensure safe production; generally speaking, the machine tool needs to be placed in a clean and bright workshop, and the ground needs to be flat;

 

          The common fault treatment of high-speed blister machine has the following points:

 

          1) If the machine does not start: the input wire is blocked, the power cord is connected reversely, and the voltage is not working;

 

          2) The temperature measurement is not accurate: check whether the thermocouples and temperature controllers are accurate and whether they are damaged;

 

          3) The working vacuum cannot be increased: the air circuit is blocked, the hand valve or the solenoid valve is not closed, and the vacuum pump motor belt will become loose, causing the vacuum gauge to be damaged;

 

          4) The switch of the main power supply of the blister machine is tripped: the primary reason is the leakage of the input wire on the top of the heating box, and the leakage of the distribution box, the external wires are tied to the equipment, and the motor is leaking;

 

           5) The suction film of the blister machine is not in place: the main reason is that the vacuum is not good, the air leakage may not be good, the film is too thin, etc., or the work piece has been pasted with other materials, and the depth of the work piece will be Far beyond the pulling up of the film, once the suction time is too short, the film is not pulled up, or the distance between the workpieces is too close, etc. will cause this situation;

 

           Shenzhen Yonghengsheng Machinery Manufacturing Co., Ltd. has been committed to research and development for 16 years to provide Shenzhen blister machine, Shenzhen blister machine, Shenzhen vacuum blister machine, Shenzhen thick film blister machine, Shenzhen blister machine molding machine, Shenzhen thermoplastic molding machine , Blister machine hotline: 0755-84817776, if you want to know more knowledge, you can also enter the official website: www.szyongheng.cn/