Today, the editor of this website will introduce to you "How to carry out daily maintenance and maintenance of the blister forming machine", I hope you can gain something!

 1. The machine tool should be kept clean.

 2. Remove the workbench panel regularly to clean up the dust on the bottom surface of the workbench and the vacuum filter to make the vacuum pipeline unblocked.

 3. Regularly check the working condition of the quartz tube in the electric heating hob, and replace the damaged quartz tube in time.

 4. Regularly drain the accumulated water in the air filter of the air source triple-piece, add proper amount of lubricating oil to the lubricator, and adjust the amount of oil mist to an appropriate amount.

 5. Keep the oil level in the vacuum pump appropriate. If the oil level is too high, the oil will overflow from the exhaust port. If the vacuum degree of the vacuum pump is too low, it will also cause damage to the vacuum pump. Please refer to the vacuum pump operation manual for the maintenance of the vacuum pump.

   Well, the above is the relevant content of "How to carry out daily maintenance and maintenance of the blister forming machine" collected by the editor of this website for you. I hope it can be helpful to you! Shenzhen Yonghengsheng Machinery Manufacturing Co., Ltd. has been committed to research and development for 16 years to provide Shenzhen blister machine, Shenzhen blister machine, Shenzhen vacuum blister machine, Shenzhen thick film blister machine, Shenzhen blister forming machine, Shenzhen thermoforming machine, Blister machine hotline: 0755-84817776

Technical support: Mingpinhui Network

Website keywords: blister machine, vacuum blister machine, thick sheet blister machine, blister forming machine, blister machine, thermoplastic forming machine