We all know that some troubles and failures will inevitably be encountered when using a blister forming machine, so today the editor of this website will introduce you to the general troubleshooting method of the blister forming machine, hurry up and read this article with the editor. ! !

 

1. The blister film cannot be absorbed. One is that the vacuum negative pressure is not enough; the other is that the heating time is short or the heating temperature is not enough.

 

2. The blister forming film rebounds, that is, the blister forming film shrinks after the workbench is withdrawn or the workpiece is taken out. It is caused by the short blister time, insufficient glue curing or poor glue quality. The heating blister time should be appropriately extended Increase the heating temperature or replace with better quality glue.

 

3. When the blister film wrinkles on the workpiece panel, check whether the filter screen at the vacuum tube interface of the vacuum workbench is blocked. The filter screen is blocked and the vacuum negative pressure is blocked. It is easy to cause wrinkles. In addition, when the quartz in the furnace is heated When the tube is damaged, it is easy to cause uneven heating of the blister film, inconsistent surface tension of the blister film, and wrinkles. The damaged quartz tube should be checked and replaced immediately.

 Well, the above is the "Four Common Faults and Treatment Methods of Blister Molding Machines" collected by the editor of this website for you. I hope it can be helpful to you! Shenzhen Yonghengsheng Machinery Manufacturing Co., Ltd. has been committed to research and development for 16 years to provide Shenzhen blister machine, Shenzhen blister machine, Shenzhen vacuum blister machine, Shenzhen thick film blister machine, Shenzhen blister forming machine, Shenzhen thermoforming machine, Blister machine hotline: 0755-84817776

Technical support: Mingpinhui Network

Website keywords: blister machine, vacuum blister machine, thick sheet blister machine, blister forming machine, blister machine, thermoplastic forming machine