How to maintain and maintain the vacuum forming machine

 

1. Keep clean and hygienic, and remove surrounding debris and dirt in the machine after shutdown;

 

2. All sliding guide posts, bearings and sprocket must be kept in good lubrication state, and lubricated frequently;

 

3. The water filter in the air circuit should be drained once every work shift, and the lubricator should be refueled frequently to ensure the normal use of the solenoid valve and the cylinder;

 

4. Check the oil level of the vacuum pump in every work shift (the oil should not be lower than the oil level); the vacuum pump oil should be replaced once a month;

 

5. Frequently observe the amount of oil in the lubricator, adjust the amount of oil in a timely manner, and increase it when the new machine works (about 1 bottle of oil in 3 days) after one week of use, it can be reduced to ensure sufficient lubrication of all pneumatic components.

 

 The above 5 points are common sense for daily maintenance of vacuum blister machine! ! I hope everyone can gain something after reading it! Shenzhen Yonghengsheng Machinery Manufacturing Co., Ltd. has been committed to research and development for 16 years to provide Shenzhen blister machine, Shenzhen blister machine, Shenzhen vacuum blister machine, Shenzhen thick film blister machine, Shenzhen blister forming machine, Shenzhen thermoforming machine, Blister machine hotline: 0755-84817776

Technical support: Mingpinhui Network

Website keywords: blister machine, vacuum blister machine, thick sheet blister machine, blister forming machine, blister machine, thermoplastic forming machine