
News
What is the reason why the vacuum degree does not rise when the blister machine is working?
- Categories:Company News
- Author:
- Origin:
- Time of issue:2017-05-05 00:00
- Views:
We all know that we will inevitably encounter some troubles when using the vacuum blister machine, so what is the reason for the vacuum degree when the blister machine is working? Today, the editor specially collected and sorted out solutions for the problem of vacuum failure when working with the blister machine:
1. First, find out the reason, and check from four places of the blister machine:
1. Gas path
2. Solenoid valve
3. Vacuum pump motor belt
4. Vacuum gauge
2. Then you can deal with the problem according to the inspection of the blister machine. The most common situation is:
1. The air path of the blister machine is blocked
2. The solenoid valve is open
3. The vacuum pump motor belt of the blister machine is not tight, leaving the original position
4. The vacuum gauge of the blister machine is no longer useful
If these problems are not solved, the operation of the blister machine will be unstable and defective products will be easily produced. For example: the position is not accurate when sucking the film; the film will automatically pull down and rise before the blister machine starts sucking and covering.
Solution:
1. Keep the air path of the blister machine unobstructed
2. Close the solenoid valve of the blister machine
3. The vacuum pump motor belt of the blister machine should be tightened back. If it fails, replace it with a new one
4. Put a high-quality vacuum gauge on the blister machine
The above is just a treatment method for the vacuum not to rise when the blister machine is working. Small problems will inevitably occur when the blister machine works for a long time, and it is not a quality problem. Moreover, each problem is well-documented, and it is important to investigate in time, and it is not difficult to deal with it.
Before the blister machine is used, when it is used, and after it is used, if the operator has completed the three points of comprehensive inspection, correct operation and maintenance of the blister machine, it will not only ensure the more efficient work of the blister machine , But also greatly reduce maintenance costs.
Okay, the above is what the editor of this website has collected for you about "What is the reason for the vacuum not to rise when the blister machine is working?" And the solution! 》Shenzhen Yonghengsheng Machinery Manufacturing Co., Ltd. has been committed to research and development for 16 years to provide Shenzhen blister machine, Shenzhen blister machine, Shenzhen vacuum blister machine, Shenzhen thick film blister machine, Shenzhen blister forming machine, Shenzhen thermoforming machine , Blister machine hotline: 0755-84817776
Technical support: Mingpinhui Network
Website keywords: blister machine, vacuum blister machine, thick sheet blister machine, blister forming machine, blister machine, thermoplastic forming machine
Shenzhen Yonghengsheng Machinery Manufacturing
Co., Ltd.
Phone: 0755-84817776 84807776
Fax: 0755-84808776
Mobile Phone:13828714526 屈先生
Email: yongheng@szyongheng.cn
Address: Building a, No.22, South Pingxi Road, Pingxi community, Pingdi street, Longgang District, Shenzhen
Copyright ©2020 Shenzhen Yonghengsheng Machinery Manufacturing Co., Ltd. 粤ICP备05089896号 by: www.300.cn